Connecting the Hardware
This chapter introduces the hardware connections, including the BMS and inverter, required to operate the BSC.
1. Connecting the BMS to the BSC¶
The BSC must be switched off before connecting the BMS. This example uses a LILYGO T-CONNECT with three RS485 interfaces. Each interface can be assigned one BMS type. If the BMS supports daisy chaining, several BMS units of the same type can share one RS485 port.
Further information:
- Supported BMS Units
- BMS Connection Examples
- RS485 Port Assignment on the LILYGO T-CONNECT
- RS485 Connector Pinout on the LILYGO T-CONNECT
To request support for another BMS, open an issue in the repository: BSC Firmware Issues.
2. Connecting the Inverter to the BSC¶
The inverter connects to the BSC via the CAN interface. The BSC must be switched off before making this connection.
Further information: